Panasonic SAEN25 Cd Radio Cassette

Panasonic SAEN25 - DESKTOP CD AUDIO SYS Manual

Panasonic SAEN25 manual content summary:

  • Panasonic SAEN25 | Cd Radio Cassette - Page 1
    reference. These instructions are applicable to the following systems. System Main unit Speakers SC-EN25 SA-EN25 SB-EN25 SC-EN26 SA-EN26 SB-EN26 SC-EN27 is used in the illustrations unless otherwise mentioned. SC-EN27 SA-EN27 SB-EN25 Troubleshooting guide Before requesting service, make the
  • Panasonic SAEN25 | Cd Radio Cassette - Page 2
    Remote control (N2QAGB000037) SC-EN25/SC-EN26 2 Batteries (N2QAGB000038) SC-EN27 1 AC power supply cord (RJA0065-1D) 1 FM/AM antenna service PHONES Portable audio player Use Remote control Plug type: 3.5 mm (1/8″ ) stereo MUSIC PORT Start Playback from the Select "MUSIC instruction manual
  • Panasonic SAEN25 | Cd Radio Cassette - Page 3
    . Press [;] again to close. 2 Start play. Main unit Remote control Elapsed playing time of track Track number CD q/h Note If 4 5 6 TIMER SET/CHECK 7 8 9 PGM/CLEAR -AUTO PRESET 0 >=10 MUSIC PORT TUNER/ CD BAND Input using the numbered buttons To select a 2-digit number e.g. 16
  • Panasonic SAEN25 | Cd Radio Cassette - Page 4
    9 PGM/CLEAR -AUTO PRESET 0 >=10 MUSIC PORT TUNER/ CD BAND VOL VOL SOUND LIVE PLAY EQ VIRTUALIZER MODE ALBUM Input using the numbered buttons To select a 2-digit number e.g. 11: [ 10] → [1] → [1] To adjust the volume SC-EN27 SC-EN25/SC-EN26 u ALBUM i PRESET TUNE Allocation settings
  • Panasonic SAEN25 | Cd Radio Cassette - Page 5
    " PLAY OFF Select the end time • Press and hold to change the time faster. CLOCK/ TIMER ADJ 2 Select the source and adjust the volume MUSIC PORT TUNER/ CD BAND q/h VOL 3 4 VOL Select the source Adjust the volume 3 Turn the timer on TIMER SET/CHECK Display "zPLAY" PLAY Turn the unit
  • Panasonic SAEN25 | Cd Radio Cassette - Page 6
    PGM/CLEAR -AUTO PRESET 0 >=10 MUSIC PORT TUNER/ CD BAND SC-EN27 SC-EN25/SC-EN26 u ALBUM i PRESET TUNE VOL VOL SOUND LIVE PLAY EQ VIRTUALIZER MODE ALBUM The shaded buttons, such as , function in the same way as the buttons on the remote control. Standby/on switch [^, POWER ^/l 3 Press
  • Panasonic SAEN25 | Cd Radio Cassette - Page 7
    with the manufacturer's instructions. 8) Do not Refer all servicing to qualified service personnel. Servicing is required Reorient or relocate the receiving antenna. • Increase the separation Panasonic Corporation of North America One Panasonic General MUSIC PORT: 3.5 mm stereo (33 kΩ) PHONES: 3.5
  • Panasonic SAEN25 | Cd Radio Cassette - Page 8
    in performance; or (e) The unit has been dropped or the cabinet damaged. 2. Servicing - Do not attempt to service the unit beyond that described in these operating instructions. Refer all other servicing to authorized servicing personnel. 3. Replacement parts - When parts need replacing ensure the
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

Operating Instructions
CD Stereo System
Model No.
SC-EN27
SC-EN26
SC-EN25
System
SC-EN25
SC-EN26
SC-EN27
Main unit
SA-EN25
SA-EN26
SA-EN27
Speakers
SB-EN25
SB-EN26
SB-EN25
SC-EN27 is used in
the illustrations unless otherwise mentioned.
These instructions are applicable to the following systems.
Dear Customer
Thank you for purchasing this product.
Before connecting, operating or adjusting this product, please read the
instructions completely.
Please keep this manual for future reference.
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the problem,
refer to the “Customer Services Directory” on page 8 if you reside in the U.S.A., or refer to the “Limited Warranty” on page 8 if you reside in Canada.
No play.
• The disc isn’t correctly set.
• The disc is scratched or dirty. (Tracks skipped.)
There is moisture on the lens. Wait for about an
hour and then try again.
MP3 cannot be read.
(SC-EN27)
You may not be able to play MP3 if you have copied
a multi-session disc that has no data between
sessions.
When creating a multi session disc, it is necessary
to close the session.
The amount of data on the disc is too small. Set the
amount of data to greater than approximately 5 MB.
Sound is un
xed,
reversed or comes
from one speaker only.
• Check the speaker connections. (
page 2)
No sound or there is a
lot of noise.
Noise may occur when playing MP3 if recording
quality is poor.(SC-EN27)
• Keep this unit away from mobile telephones.
• Turn the volume up.
Switch the unit off, determine and correct the cause,
then switch the unit on. Causes include shorting of
the positive and negative speaker wires, straining of
the speakers through excessive volume or power,
and using the unit in a hot environment.
Humming heard during
play.
An AC power supply cord or
uorescent light is near
the cords. Keep other appliances and cords away
from this unit’s cords.
This product may receive radio interference caused by mobile telephones during
use.
If such interference is apparent, please increase separation between the
product and the mobile telephone.
A beat sound is heard
while receiving a radio
broadcast.
• Switch the TV off or separate it from the unit.
A low hum or noise is
heard during AM
broadcasts.
Keep the antenna away from other cables and
cords.
• Keep the AM antenna away from the unit.
The picture on the
television near the set
disappears or stripes
appear on the screen.
The location and orientation of the antenna are
incorrect.
The TV antenna wire is too close to the unit.
Separate the antenna wire of the TV set from the
unit.
Remote control
doesn’t work.
Check that the batteries are inserted correctly. (
page 2)
• Replace the batteries if they are worn.
Display
– –:– –
You plugged the AC power supply cord in for the
rst
time or there was a power failure recently. Set the
time. (
page 5)
The total programmed play time is more than 200
minutes.
Tracks can still be programmed and played.
FULL
The number of programmed tracks is limited to 24.
No further tracks can be programmed.
NO/MP3
A CD-ROM disc that is not CD-DA or MP3 format is
inserted.
It cannot be played.
ERROR
Incorrect operation performed. Read the instructions
and try again.
F76
There is a power supply problem. Consult the
dealer.
Panasonic Consumer Electronics
Company, Division of Panasonic
Corporation of North America
One Panasonic Way Secaucus,
New Jersey 07094
Panasonic Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985
Panasonic Canada Inc.
5770 Ambler Drive
Mississauga, Ontario
L4W 2T3
www.panasonic.ca
© 2005 Matsushita Electric Industrial Co., Ltd.
Printed in China
RQT8520-P
M1205KS0
P
PC
En